Turning The Power On And Off; Switching Audio Sources; Adjusting The Sound - Toyota TNS400 Owner's Manual

4.. Turning the power on and off

When the power is turned on, the status in use when the power was last turned off, such as CD
and tuner playback, is restored.
1. When the power is OFF, press the [SOURCE/PWR] button.
The power will come ON.
2. When the power is ON, press the [SOURCE/PWR] button for more than one second.
All audio sources will be turned OFF.
"GOOD BYE" will be displayed.
3. When the power is ON, press the [SOURCE/PWR] button for more than 5 seconds.
The power will go completely OFF.
"ACC OFF" will be displayed.
Attention:
• When the main unit's power is turned on for the first time or if the battery terminals have
been disconnected, e.g. for vehicle maintenance, and the power is then turned back on,
the main unit will start up in FM mode. After this, the broadcast stations will be searched for
automatically (ASM - Automatic Search Mode) and registered to preset numbers [] to [6].
• If your vehicle is not equipped with the "ACC" position, press the [SOURCE/PWR] button until
"ACC OFF" is displayed.

4.. Switching audio sources

Press the [SOURCE/PWR] button to switch the audio source in the following sequence:
TUNER → CDP → USB
*
* : Cannot be selected if the corresponding device is not connected to the main unit.
* : Cannot be selected if no CD is inserted.
* : Cannot be selected if the AUX setting is set to OFF.
* 4: If the TomTom is not connected to the main unit, you cannot select the USB mode or iPod
mode.

4.. Adjusting the sound

Adjusting the volume
Turn the [VOL] rotary knob.
Turn to the right: Increases the volume.
Turn to the left: Decreases the volume.
Caution: Do not adjust the volume or other controls while driving the vehicle. Do so only
while parked in a safe location.
4 TNS400
→ AUX → iPod
**4 * **4
→ TUNER → ...