Water Supply (Cold Water Only) - Kärcher K 502 MS plus User Manual

IMPORTANT PRECAUTIONS – continued
WARNING
• DO NOT USE WITH FLAMMABLE LIQUIDS AND TOXIC CHEMICALS
• INJECTION HAZARD: EQUIPMENT CAN CAUSE SERIOUS INJURY IF THE SPRAY
PENETRATES THE SKIN. DO NOT POINT THE GUN AT ANYONE OR ANY PART OF THE
BODY. IN CASE OF PENETRATION SEEK MEDICAL AID IMMEDIATELY.
• THIS SYSTEM IS CAPABLE OF PRODUCIN
DO NOT OPERATE THIS PUMP WITH COMPONENTS RATED LESS THAN
KING PRESSURE (INCLUDING BUT NOT LIMITED TO SPRAY GUNS, HOSE AND HOSE
CONNECTIONS).
• BEFORE SERVICING, CLEANING OR REMOVAL ANY PARTS, SHUT OFF POWER AND
RELIEVE PRESSURE.

Water Supply (Cold Water Only)

• Water hose must be at least 3/4 inch in diameter.
• Flow rate of water supply must not fall below 2 GPM (gallons per minute).
• Flow rate can be determined by running the water for one minute into an
• The water supply temperature must not exceed 104°F/40°C.
• Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners,
gasoline, oil, etc.
NOTE: Dirt in the feed water could lead to the unit being damaged. To avoid this risk, we recommend
fitting a filter.
• Always prevent debris from being drawn into the unit by using a clean water source and an accessory
water filter if required.
THE BEST ANTI-FREEZE PROTECTION IS PROVIDED BY
STORING THE MACHINE IN SHELTERED SPACE
4
1500 PSI. TO AVOID RUPTURE AND INJURY,
1500 PSI WOR-
empty 5 gallon container.