Water Supply (Cold Water Only) - Kärcher G3200XH Operator's Manual

CAUTION
When connecting to water supply mains, local
regulations of your municipal water company
must be observed. In some areas connecting
directly to public drinking water supply may
require a backfl ow prevention device. This is
to ensure that there is no feedback of chemi-
cals into the water supply. Use a water fi lter to
avoid potential damage from dirt in the water
supply.
Garden hose must be at least 5/8 inch
■
diameter.
■ Flow rate of water supply must not fall below
2.5 GPM (gallons per minute)
Description
7/16" (or 11mm) Wrench Stamped
Description
A
Joint
B 1/4" Nut
C
1/4" Bolt
D
3/8" Bolt
E Knob
F Anchor
Rivet

WATER SUPPLY (Cold Water Only)

ASSEMBLY INSTRUCTIONS
Required Tools (included)
Hardware (included)
Purpose
Joint Assembly
Joint Assembly
Joint Assembly
Joint Assembly
Joint Assembly
Nozzle Holder Assembly
■ Flow rate can be determined by running the
water for one minute into an empty 5-gallon
container.
The water supply temperature must not ex-
■
ceed 104°F/40°C.
Never use the pressure washer to draw in
■
water contaminated with solvents, e.g. paint
thinners, gasoline, oil, etc.
■ Always prevent debris from being drawn into
the unit by using a clean water source. Use
additional water fi lter.
■ Do not operate pressure washer without the
water turned on.
Illustration Qty
4
4
4
2
2
4
English 5