Operation; Water Supply; Description Of The Appliance; Before Startup - Kärcher K 2.050 Operating Instructions Manual

Operation

Description of the Appliance

Illustrations on Page 2
1 High pressure connection
2 Appliance switch "0/OFF"/ „I/ON"
3 Storage for high pressure hose
4 Carrying handle
5 Storage for spray lance
6 Connection for water supply with filter
7 Detergent suction hose (with sieve)
8 Coupling element for water connection
9 Garden hose connector (female)
10 Mains cable with mains plug
11 Trigger gun
12 Lock trigger gun
13 Clamp for high pressure hose
14 High pressure hose
15 Spray lance with Dirtblaster
16 Spray lance with high pressure nozzle
Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.

Before Startup

Mount loose parts delivered with appliance
prior to start-up.
Illustrations on Page 2
Illustration
 Insert the transport handle.
Illustration
 Pull out the clamp for the high-pressure
hose from the trigger gun (e.g. with a
small screwdriver).
Illustration
 Connect high pressure hose to trigger
gun.
 Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
6 English

Water supply

According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
 Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
 Illustration
1 Screw the supplied coupling element to
unit's water inlet.
2 Screw the supplied garden hose con-
nector on to the end of your garden
hose.
3 Push the garden hose connector on to
the water inlet connector and make
sure you hear it click into place before
proceeding.
 Connect garden hose to the cold water
source and turn water on completely.