Table of Contents
Advertisement
4. OPERATION
Operation with the GARDENA
smart system App:
Setting options for the
Gateway:
1. Connect to the GARDENA configuration network. Use the last
eight digits of your gateway ID as the password (see graphic).
The gateway ID can be found on the sticker on the underside of
the gateway.
2. Open the URL:
http://10.0.0.1
in your preferred Internet browser.
You should now see the Gateway Interface.
3. Login using the first eight digits of your Gateway ID as the
password (see graphic).
4. Select your network from Wi-Fi.
Then your Gateway is connected with the Internet.
5. Enter your network password and confirm your settings. Wait until
the Internet-LED turns green. This can take a few minutes.
The software for your Gateway is now being updated.This can
take a few minutes. During this time, the Internet LED may flash
red and the Power LED may flash yellow. Once the Internet-LED
and the Power-LED stay green, your Gateway is up to date. It can
now be included it in the App.
6. Download the GARDENA smart system app from the Apple App
Store or the Google Play Store.
7. Follow the instructions in the App.
Note: This hotspot network does not provide an Internet access.
Some devices will automatically ignore and disconnect from the
GARDENA hotspot network. In this case you will have to disable
that option on your device. Also, make sure JavaScript is activated
and browser cookies are accepted, in order to display the page
correctly. Connecting the Gateway is not supported by Internet
Explorer.
If the internal antennas do not have a long enough radio range,
external short distance radio antennas can be screwed on to the two
(6)
gateway connections
You can use the GARDENA smart system app to control all smart
system devices from anywhere at any time. You can download the
free GARDENA smart system app from the Apple App Store or from
the Google Play Store.
Make sure that the smart gateway was successfully commissioned
(see 3. INITIAL OPERATION) before connecting it to the app.
All GARDENA smart devices are integrated via the app. Follow the
instructions inside the App.
– Configure Ethernet
– Setting up Wi-Fi
– Set up external short-range wireless antennas
– Configure time zone
(available as an option through Service).
5
Advertisement
Table of Contents
