Gardena 19000 Operator's Manual page 4

Commissioning the
smart Gateway:
6 4 5 6
Power-LED
Connection-LED
Internet-LED
4
An Internet connection is required for installation of the Gateway.
The Gateway can be connected to the Internet via LAN or Wi-Fi.
1. Connect the Gateway with the provided power supply unit.
During the self-test, the Power LED
approx. ten seconds and then flashes green.
2. Wait until the Power-LED stays green.
This can take up to one minute. After this you can connect the
Gateway with the Internet.
3. Select one of the following options:
Connecting via cable / Connecting via Wi-Fi.
Connecting via cable (recommended):
1. Connect the Gateway with the provided network cable to your
router.
The software for your Gateway is now being updated.This can
take a few minutes. During this time, the Internet LED may flash
red and the Power LED may flash yellow. Once the Internet-LED
and the Power-LED stay green, your Gateway is up to date. It can
now be included it in the App.
2. Download the GARDENA smart system app from the Apple App
Store or the Google Play Store.
3. Follow the instructions in the App.
Connecting via Wi-Fi:
The Gateway automatically provides a GARDENA hotspot network
if it is not connected to the Internet. Once the Internet-LED turns and
stays yellow, the hotspot network will be visible. The graphic below
shows a typical network name.
Name
GARDENA hotspot network:
GARDENA_config(9eb7)
Gateway ID: 9eb74563-e89b-12d3-a456-426655446548
Password Gateway Interface:
9eb74563
(1)
lights up green for
Password
GARDENA hotspot network:
55446548