Bus Zones Configuration - Risco LightSYS Installation And Programming Manual

Quick Keys

 
Parameter

Bus Zones Configuration

The Bus Zone Parameters menu contains parameters that enable you to
program the special parameters of a bus zone. The options are
determined according to the bus detector type:

Lunar Grade 3: A dual technology ceiling detector with a
mounting height of up to 8.6m (28ft) that incorporates Anti-
Cloak TM Technology (ACT).

WatchOUT DT: A dual technology outdoor detector with signal
processing based on two Passive Infrared (PIR) channels and two
Microwave (MW) channels.

WatchOUT PIR: An outdoor detector with signal processing based
on two Passive Infrared (PIR) correlated channels

WatchIN DT Grade 3: A dual technology Grade 3 industrial
detector with signal processing based on two Passive Infrared (PIR)
channels and two Microwave (MW) channels.

iWISE QUAD Grade 2: A motion detector incorporating Quad PIR
technology

iWISE DT Grade 3: A motion detector incorporating both Anti-
Mask and Anti-Cloak
environmentally friendly guidelines and is available in 15m and
25m models.

iWISE QUAD Grade 3: A motion detector incorporating Anti-Mask
and Quad PIR technologies.
Use the instructions below to set parameters for the relevant bus zone
detector.
Default
TM Technologies (ACT). It adheres to
Page 97
Engineer Programming
Range