Table of Contents
Advertisement
WARNINGS AND CAUTIONS
WARNING
•
If the information in this manual is not followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
•
Improper installation, adjustment, alteration, service, or maintenance can cause injury or
property damage. Refer to this manual for correct installation and operational procedures.
For assistance or additional information consult a qualified installer, service agency, or the
gas supplier.
•
This appliance requires a 1/2 in. NPT (National Pipe Thread) inlet connection to the pressure
regulator.
•
A qualified service person must connect log set to gas supply. Follow all local codes.
•
Never connect natural gas appliance to private (non-utility) gas wells. This gas is commonly
known as wellhead gas.
•
Use pipe joint sealant that is resistant to liquid petroleum (LP) gas.
•
Test all gas piping and connections for leaks after installing or servicing. Correct all leaks at
once.
•
Never use an open flame to check for a leak. Apply a noncorrosive leak detection fluid to all
joints. Bubbles forming show a leak. Correct all leaks at once.
•
You must use a ON/OFF safety valve/pilot kit for propane/LP conversion.
CAUTION
•
Never connect propane/LP appliance directly to the propane/LP supply. This appliance
requires an external regulator (not supplied). Install the external regulator between the
appliance and propane/LP supply.
•
Use only new, black iron or steel pipe. Internally-tinned copper tubing may be used in certain
areas. Check your local codes. Use pipe of 1/2 in. diameter or greater to allow proper gas
volume to log set. If pipe is too small, undue loss of volume will occur.
•
For additional convenience and safety, this ON/OFF Valve/Safety Pilot Kit can be used with
natural gas as well. If you are unsure of the proper application, call our customer service at
866-573-0674 for further information.
•
If the fireplace does not have a gas supply shutoff valve, one must be installed.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list. If any part is missing or damaged, do not attempt to assemble the
product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 minutes
Tools Required for Assembly (not included): Philips Screwdriver, Pipe Sealant, Adjustable
Wrench Sediment Trap and Manual Shutoff Valve.
Helpful Tools (not included): 10 mm Socket or Nut Driver.
3
Advertisement
Table of Contents
