Table of Contents
Advertisement
Installing Splash Guard
1. Attach the splash guard (tall side to the left)
to the table, with four phillips pan head
machine screws and four flat washers. See
Figure 5. The rear splash plate should be
secured to the splash guard with wing nuts
and flat washers, and the tinted front splash
plate should be installed in the tabs at the
front of the splash guard.
Installing Coolant System
1. Blow out coolant tank with an air hose to
remove any dirt and debris.
2. The coolant system should be placed on the
left side of the machine.
3. Connect the hose from the coolant pump to
the fitting on the wheel guard. See Figure 6.
4. Connect the drain hose from the tank intake
to the drainage port at the left bottom side of
the saddle See Figure 7.
Disconnect machine from
power
source
before
connections. Electrical connections must be
made by a qualified electrician in compliance
with all relevant codes.
5. Run the power cable coming from the
coolant pump through the electrical cabinet.
Match up wires U2, V2, W2 and Ground
wire to the terminal strip. (Consult the wiring
diagrams inside the cover of the coolant
pump and electrical cabinet.)
Do not start the coolant
pump until coolant has been added.
6. The coolant should be visible, anti-high
pressure,
soluble
coolant must be non-flammable. Coolant
mix should be 1/60 to 1/80 for normal
surface grinding.
7. Pour the coolant mixture into the enclosure
below the coolant pump.
Installing Grinding Wheel
Visually check the wheel for any cracks or
damage. Make sure it is the correct size for your
grinder. Then proceed with a "ring" test, as
follows:
1. Suspend the wheel with your finger or a
wooden stick through the hole.
2. Using a wood mallet, tap the wheel about
45° each side of the vertical center line and
1 to 2 inches from the center.
making
electrical
and
non-foam.
The
Figure 5
Figure 6
Figure 7
12
Hide quick links:
Advertisement
Table of Contents
