Related Manuals for Jet JAT-400
Summary of Contents for Jet JAT-400
- Page 1 Pneumatic Micro Die Grinder #505400, JAT-400 Operation & Parts Manual M-505400 Edition 1 02/2015 427 New Sanford Road LaVergne, TN 37086 Ph.: 800-274-6848 www.jettools.com Copyright © 2015 JET...
-
Page 2: Warranty And Service
Accessories; Shop Tools; Warehouse & Dock products; Hand Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand. -
Page 3: Safety Warnings
10. The air tool must be properly lubricated before operating. Do not use this tool for other than its intended use. If used for other purposes, JET disclaims 11. Never start a percussion type air tool (chipper, any real or implied warranty and holds itself breaker, buster, etc.) without securing the... - Page 4 33. Do not lubricate the tool with combustible or storing tool. liquids, such as kerosene, diesel or jet fuel. 23. Make sure tool is switched off, and your finger 34. Do not dispose of this tool with normal off the trigger, before connecting to air supply.
-
Page 5: About This Manual
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com. -
Page 6: Tool Specifications
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations. -
Page 7: Setup And Assembly
(not included) into collet, and retighten collet nut securely with wrench. Any missing parts or damage should be reported ® immediately to your JET distributor. Do not use a Blow out air line to remove any dirt or damaged tool. Read this instruction manual... - Page 8 (See also “Troubleshooting” Use a light oil containing rust inhibitors, such as section.) SAE #10. Many JET air tools have integral oil • reservoirs, which should be kept filled when in-line Contaminated air such as a dirty air system oilers are not used.
- Page 9 Figure 2 Recommended arrangement of air piping and air line system ...
- Page 10 Troubleshooting JAT-400 Micro Die Grinder Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or obstructed.
- Page 11 #505400, JAT-400, 1/8-inch Micro Die Grinder – parts breakdown Index Part No. Description Index Part No. Description JAT400-01 Rear end holder JAT400-16 Spacer JAT400-02 Set screw M4x3L JAT400-17 Lateral disc JAT400-03 O-Ring ø14x10 JAT400-18 Ball bearing 695T12ZZ JAT400-04 Air regulator JAT400-19 Inner retainer bearing bushing JAT400-05 O-Ring ø3x2.1...
-
Page 12: Replacement Parts
Replacement parts To order parts or reach our service department, call 1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Please have the stock number and serial number of your tool available when you call, so that we may serve you quickly and accurately. ...