Table of Contents
Advertisement
Installation
3
Use the backplate as a template to mark the wall locations for drilling the mounting holes
.
4
Drill pilot holes and attach the backplate to the backboard with the four No. 10 x
and washers supplied with the remote enclosure.
5
Attach the remote enclosure to the backplate. To allow the enclosure to hinge either up or down, remove the
bottom or top retaining screws respectively.
When the main chassis is attached to the backplate, it can be rotated up or down to provide
access to the backplane connector and other internal areas. See
6
Rotate the main chassis back into position and replace the retaining screws
6
0.00"
Figure 6. HRE-206 Backplate
Top retaining
Top
HRE-206
(side view)
Figure 7. Wall Mounting and Bottom-Hinged View
June 1, 2001
Mounting holes
Mounting holes
.
Exposed
backplane
screw
Hinge
LTPH-TP-1003-02, Issue 2
(Figure
6).
5
/
-inch sheet metal screws
8
Figure 7
for hinging details.
(Figure
7).
Wall
HRE-206 Lists 1 and 2
Advertisement
Table of Contents
