•
An emergency method to reset the IOLM to factory defaults, so that
software can be used to program the appropriate IP address, and
then reset the switches to 000.
Note: If you set the network address using the rotary switches, the rotary
switch setting overrides the network settings in the web interface when
the IOLM is initially powered on or after cycling the power.
Note: The default subnet mask is 255.255.255.0
1. Gently swing open the switch window from the top to the
bottom, allowing it to pivot on the hinge on the bottom of the
window.
2. Turn each dial to the appropriate position using a small flathead
screwdriver.
Figure 3: Rotary Switches
The default setting is 000 as shown above.
11
IO-LINK Master W/ PROFINET and Modbus Quick Start Guide
GFK-3213A