Important Information; Safety Instruction; General; Safety Issues - Linak HOMELINE LA10 system User Manual

Important information

Important information on LINAK
Warnings
Failing to follow these instructions may cause accidents resulting in serious personal injury�
Recommendations
Failing to follow these instructions can result in product damage�

Safety instruction

General

Safe use of the system is possible only when the operating instructions are read completely and the
instructions contained are strictly observed�
Failure to comply with instructions marked with the "NOTE" symbol may result in serious damage to the
system or one of its components�
It is important for everyone who is to connect, install, or use the systems to have the necessary
information and access to this User Manual� Follow the instructions for mounting – risk of injury if
these instructions are not followed�
The appliance is not intended for use by young children or infirm persons without supervision�
If there is visible damage on the product it must not be installed�
Note that during construction of applications, in which the actuator is to be fitted, there must be no
possibility of personal injury, for example the squeezing of fingers or arms�
Only the power supply type SMPS001 or SMPS006, shall be used with the system (LA10 System)�
The power supply shall not be covered while operating to allow sufficient cooling of this appliance�
The appliance is only to be used with the power supply unit provided with the appliance�
Furthermore take care about the connecting wires from the power supply to the LA10 System, do
not damage this by overrun�
Assure free space for movement of application in both directions to avoid blockade�

Safety issues

The builder of the equipment shall ensure that the use of the component complies with relevant
standards – like the Machine Directive� Care must be taken to avoid squeezing of cables as it can
cause movement of the system!
The SMPS001/006 must not be packed in heat insulating material, but must be placed so that it can
emit waste heat to the surroundings� There are no ventilation holes to consider, the SMPS emits heat
through its surface�
Only the power supply type SMPS001 or SMPS006, or similar suited products meeting the
requirements EN 60335-1, shall be used with the system (LA10 system).
products can be found under the following headings:
®
LA10 system | 5