Pairing The Remote; Initialising The System; Re-Initialising The System - Linak HOMELINE LA10 system User Manual

Pairing the remote

When connecting the system to power, it will automatically be in pairing mode for three minutes� The
pairing mode stops when a paired remote sends a command�
1� Press the two upper buttons of the control unit to pair it with the system�
For BP11: press the 'up' and the 'down' buttons�
If you need to get the system into pairing mode, unplug the system, wait for 10 seconds, and plug
the power cable back in�
There is no need to initialise the system when setting it up for the first time� You just need to
connect it and pair the control�

Initialising the system

1� Push the "down" button on the control unit for the actuator that must be initialised and drive the
actuator to its inner position�
2� Release the button on the control unit�
If more than one actuator is connected, the same must be done with the other channels by pressing the
matching "down" button on the control unit� The system is now ready for use�

Re-initialising the system

If the system needs to re-initialised, please follow this procedure:
1� Press and hold the "down" button for 10 seconds to make the actuator initialise – the actuator can
now drive outwards�
LA10 system | 19