Presetting Stations; Playing Back Discs - JVC RV-NB20BC Instructions Manual

Presetting stations

You can preset up to 30 FM stations and 15 AM stations.
Note: Preset numbers may have been set to factory test
frequencies prior to shipment. This is not a malfunction.
You can preset the stations you want into memory as
follows:
Using the remote control only
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start again from step
1. Press FM/AM repeatedly to select either
FM or AM.
2. Press 4 or x to tune in to a station.
3. Press SET.

Playing back discs

CANCEL
Number
buttons
7
4
CD 6
x
PLAY MODE
REPEAT
This system has been designed to play back the following discs—
CD, finalized CD-R/CD-RW (recorded in audio CD format) and
CD-R/CD-RW (in MP3 format).
• This system is not compatible with the other discs such as DVD,
DVD-R, and DVD-RW.
Notes on MP3:
• The system can only recognize files (tracks) with "MP3" or
"mp3" as the extensions, which can be in any combination of
upper and lower case.
• It is recommended that you record your material at a 44.1 kHz
sampling rate, using the 128 kbps data transfer rate.
• You can play back the discs containing the tracks in music CD
format or MP3 files in ISO 9660 format.
• Some MP3 tracks or discs may not be played back because of
their characteristics or recording conditions.
• MP3 discs require a longer readout time than normal discs.
Hierarchy
Level 1 Level 2 Level 3
Group with its play order
MP3 track with its play order
.
LOCK/RELEASE
GROUP UP
knob
CD 6
GROUP DOWN
Level 4 Level 5
4. Press the number buttons to select the
preset number you want.
• To select 5, press 5.
• To select 15, press +10 then 5.
• To select 20, press +10 once then press 10.
5. Press SET.
"STORED" appears on the display and the station is stored.
6. Repeat above steps
station you want to store into memory with
a preset number.
To change the preset stations, repeat the same steps as
above to overwrite a new station.
CAUTION:
To prevent the preset stations from being erased
because of a power failure, etc., install memory
backup batteries in the system. (See pages 5 and
6.)
4
7
x
• This system recognizes up to 999 tracks on a disc (or less
depending on the recording condition of a disc).
Setting a disc
1. Turn the LOCK/RELEASE knob
counterclockwise to open the disc
compartment door.
2. Place a disc, with its label side up as
shown above.
3. Close the disc compartment door and turn
the knob to "LOCK" position.
To remove the disc, open the disc compartment door in stop
mode.
You can place an 8 cm (3-3/16") disc without an adapter.
If the disc cannot be read correctly (because it is scratched, for
example), "NO PLAY" or "NO DISC" appears on the display.
You can place a disc while listening to the other source.
to for each
10