Specifications - JVC RV-NB20BC Instructions Manual

Symptom
• The track skips.
• The disc does not play ("NO PLAY" or
"NO DISC" appears).
• Specific files (tracks) on an MP3 disc are
not played.
• iPod is not turned on.
• iPod does not play though "CONNECT"
appears on the display.
• iPod is not charged.
• Unable to operate the remote control.
• Operations are disabled.
• Indicators and the display do not light up
while in standby mode.

Specifications

Amplifier
Output Power
6 W per channel, min. RMS, at 4 Ω from 150 Hz to 15
kHz with no more than 10% total harmonic distortion.
20 W per channel woofer, min. RMS into 4 Ω at 60 Hz
with no more than 10% total harmonic distortion.
Input Sensitivity/Impedance (1 kHz)
AUX 300 mV/47 kΩ
MIC/GUITAR INPUT: Switchable
200 Ω – 2 kΩ (6.3 mm dia. plug)
MIC
GUITAR 100 kΩ – 1 MΩ (6.3 mm dia. plug)
Output Sensitivity/Impedance (1 kHz)
16 Ω – 1 kΩ
Phones
0 – 12 mW/ch output into 32 Ω
Disc Player
Dynamic range 90 dB
Signal-to-noise ratio 95 dB
Wow and Flutter Unmeasurable
Possible cause
• The disc is dirty or scratched.
• The disc is upside down.
• The disc is dirty or scratched.
• Files other than MP3 are included in the
disc.
• Connection is not firmly made.
• The battery of the iPod is empty.
• FM/AM is selected as the source.
• The system is in a standby mode when
the system is operated on the batteries or
the car battery (DC12V).
• The path between the remote control and
the sensor on the system is blocked.
• The batteries have lost their charge.
• The built-in microprocessor has
malfunctioned due to external electrical
interference.
• Batteries or DC power is used to supply
the power.
Tuner
FM Tuner
Tuning Range
AM Tuner
Tuning Range
Antenna
Speakers
Full range
Super woofer
General
Dimensions
Mass
Power Specifications
Power Requirements
Power Supply to iPod
Power Consumption
AC 120 V
External DC 12 V
Design and specifications are subject to change without notice.
Action
• Clean or replace the disc.
• Put the disc in with the label side up.
• Change the disc.
• They cannot be played.
• Check the connection. (See page 6.)
• Leave the iPod connected for more than
approximately ten minutes.
• Select any source other than FM/AM.
• Turn on the system.
• Remove the obstruction.
• Replace the batteries.
• Unplug the system then plug it back in
after a few minutes.
87.5 MHz – 108.0 MHz
530 kHz – 1 710 kHz
FM telescopic antenna
Ferrite core antenna for AM
8 cm × 2, 4 Ω
16 cm × 2, 4 Ω
690 mm × 239 mm × 293 mm (W/H/D)
9.2 kg (without batteries)
10.3 kg (with batteries)
AC 120 V , 60 Hz
DC 15 V ("R20/D(13F)" batteries [10])
External DC 12 V (car battery via
optional CA-R120 car adapter)
5 V/500 mA
, 60 Hz 50 W (power on mode)
1.3 W (in standby mode)
2.5 A (power on mode)
18