Listening To Fm And Am Broadcasts; Tuning In A Station; Presetting Stations - JVC UX-M6V Instructions Manual

Listening to FM and AM Broadcasts

Tuning In a Station

1 Press TUNER/BAND to select tuner mode.
The unit automatically turns on, and tunes in the last
station tuned in (either FM or AM).
2 Press TUNER/BAND to select
the band, FM or AM.
Each time you press the button, the band
selection alternates between FM and
AM.
3 Press and hold 4 or ¢
until "SEARCH" appears, then
release the button.
The unit starts searching for stations.
When a station of sufficient signal strength is tuned in,
searching stops and the TUNED indicator lights up on the
display.
If a program is broadcast in stereo, the STEREO indicator
lights up.
To stop searching, press 4 or ¢.
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
To improve the FM reception
When an FM stereo broadcast is hard to receive
or noisy, press FM MODE/VOCAL to switch
to the monaural reception. The STEREO
indicator disappears from the display.
To restore the stereo reception, press FM MODE/VOCAL
again so that the STEREO indicator lights up.
To change FM/AM tuning interval
The unit's default tuning interval is 50 kHz/step for FM
reception and 9 kHz/step for AM. You can change this setting
when using the unit in an area where the frequency allocation
is 100 kHz/step for FM stations and 10 kHz/step for AM
stations.
1 Unplug the AC power cord.
2 Press and hold 3/8 and VOLUME – on the unit
simultaneously.
3 Plug in the AC power cord.
4 Release the buttons.
To switch the tuning interval back to 50 kHz/step (FM)
and 9 kHz/step (AM), follow the same procedure above
except in step 2 where you press and hold 8/2 and
VOLUME + simultaneously.

Presetting Stations

You can preset 20 FM and 10 AM stations.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1 Tune in the station you want to preset.
BAND
TUNER
• See "Tuning in a Station" on the left.
2 Press PROGRAM.
The PRESET indicator and the current
SEARCH/TUNING
preset number start blinking on the display.
3 If you want to change the
preset number, press 8/2 or
3/8 repeatedly until the
desired preset number appears.
• Alternatively, use the number buttons on the remote
control.
To select preset number 5, press 5.
To select preset number 12, press +10 and then 2.
To select preset number 20, press +10, +10 and then 0.
4 Press PROGRAM again to
store the radio station.
"STORED" scrolls through briefly.
FM MODE
/VOCAL
The PRESET indicator lights up steadily.
5 To preset more stations, repeat the steps
above, allocating a different preset number to
each station.
When a new station is stored
The station previously memorized with the same preset
number is erased. (The frequency of the new station replaces
the previous frequency in memory.)
– 10 –
Continued
PROGRAM
PRESET
DIRECTION PLAY/PAUSE
PROGRAM