Turning Off The Sound Temporarily; Selecting The Sound Mode - JVC RV-NB20BC Instructions Manual

Turning off the sound
temporarily
Using the remote control only
Press MUTING.
"MUTING" appears on the display.
On remote control
To restore the sound, press MUTING again or adjust the volume
(see page 7).
Adjusting the super woofer
volume
During play, you can adjust the bass level between BASS 1
(minimum) and BASS 6 (maximum).
Using the system
Turn the SUPER WOOFER VOLUME +/–
control clockwise to increase the bass level
or turn it counterclockwise to decrease the
bass level.
Using the remote control
Press SUPER WOOFER VOLUME + to
increase the bass level or press SUPER
WOOFER VOLUME – to decrease it.
Note: This function is not effective when the headphones are in
use.
Activating clear sound
The Active Clear Sound (ACS) circuit emphasizes high-frequency
sound without lowering the signal-noise ratio, while adjusting its
output according to the input signal level. This results in a better
balance between the high-frequency sound and the low-frequency
heavy bass.
Press ACS (active clear sound) to turn it on
or off.
When it is turned on, the ACS ON indicator lights in red.
or
On remote control
On system
• The ACS LEVEL indicator flashes in green according to the
input signal level.

Selecting the sound mode

Sound modes can be selected to enhance the type of music being
played.
Press SOUND to select the sound mode.
Each time you press the button, the sound mode changes as
follows:
On system
Sound mode selection:
Set to this position for music with a heavy
BEAT:
beat, such as rock and disco music.
Set to this position for light music including
POP:
popular and vocal music.
Set to this position for crisp and clear
CLEAR:
sounding music with transparent highs.
FLAT (no effect): Set to this position not to apply any sound
mode.
Showing the time
While the power is turned on, you can see the current time (clock)
at any time, as follows.
Using the remote control only
Press DISPLAY.
Each time you press the button, the display changes as follows:
Current sound source (e.g. FM103.5 MHz) O (clock)
Note: To let the clock work, you need to set the clock first. (See
"Setting the clock" on page 15.)
or
On remote control
8