KTM 950 ADVENTURE 2003 Manual page 121

12-4
3
5
LUBRICATION AND MAINTENANCE WORK - ENGINE
Changing the engine oil and filter, cleaning the oil screens
and magnets on the drain plugs
NOTE: Change the engine oil when the engine is at operating
temperature.
T
CAREFUL NOT TO BURN YOURSELF
NOTE: before performing the following greasing and maintenance work,
remove the engine guard, the seat and both tanks (see page 3-2). Jack
the bike up on the center stand 600.03.022.000 and lock the center
stand (600.29.055.000). Remount in the reverse order when the
lubrication and maintenance work is completed.
– Remove the oil drain plug on the engine
– Clean the magnet on the drain plug.
– Mount a new seal ring on the drain plug, screw back in and tighten
1
– Unscrew the oil drain plug
NOTE: dispose of the used oil properly.
Do not pour the used oil into the sewer system.
1 liter of used oil will pollute 1,000,000 liters of water.
– Clean the magnet on the drain plug.
– Mount a new seal ring on the drain plug, screw back in and tighten
2
– Remove the oil screen cover
– Clean the oil screen, remount with the TOP mark facing up and
4
– Remove the oil filter cover
– Insert a new oil filter in the engine case, grease the O-ring and mount
O
FILTERS ARE USED
WARNING
HE ENGINE AND ENGINE OIL ARE VERY HOT AT OPERATING TEMPERATURE
.
into a receptacle.
to 20 Nm.
drain into a receptacle.
to 20 Nm.
with a pair of pliers.
mount the cover.
case with circlip pliers (upside-down).
the oil filter cover together with the O-ring. Tighten the bolts to
6 Nm.
! CAUTION
KTM
NLY USE ORIGINAL OIL FILTERS
.
1
and allow the oil to drain
2
on the oil tank and allow the oil to
3
and carefully pull out the oil screen
5
and pull the engine out of the engine
!
. T
HE ENGINE CAN BE DAMAGED IF OTHER
–
BE
4