When The Washing Program Is Completed, But There Is Water In The Drum; Auto Off Mode - Zanussi ZWWM25W804A User Manual

NOTE
At the end of the program, the time
remaining can suddenly decrease from
7 minutes or less to 0 due to the
overestimated total program time during
the load sensing phase. In some cases
(with perfectly balanced load) the
program time can be shorter than the
time estimated after the load sensing
phase is completed. This is a normal
behavior of the machine and not a cause
for concern as it does not compromise its
performance.
5.10 When The Washing
Program Is Completed, But
There Is Water In The Drum
(Option "Rinse Hold
-
The drum turns regularly to prevent
the creases in the laundry.
-
The indicator "Start/Pause" flashes to
remind you to drain the water.
-
The door lock indicator "
The door stays locked.
You must drain the water to
open the door.
To drain the water:
Press the "Start/Pause
1.
The appliance drains the water and
spins with the maximum spin speed
for selected program.
Alternatively, before pressing the
"Start/Pause" touchpad, you can press
the "Spin " touchpad to change the
spin speed. You can select "No Spin
( )", if you want the machine to
only drain the water.
When the program is completed and
2.
the door lock indicator "
you can open the door.
Press the "On/Off" button to deactivate
3.
the appliance.
" is used)
" is on.
" touchpad.
" goes off,
NOTE
After approximately 18 hours, if you do
not press Start/Pause touchpad, the
appliance will drain and spin automatically
(except for "Wool" program) .

5.11 AUTO Off Mode

The AUTO Off mode automatically
deactivates the appliance to decrease
the energy consumption when:
You do not press any buttons for 5
minutes before you press "Start/Pause".
-
Press the "On/Off" button to activate
the appliance again.
After 5 minutes from the end of the
washing program.
-
Press the "On/Off" button to
reactivate the appliance. Display will
show the end of the last wash.
-
Press any touchpad again to show
the last wash program.
ENGLISH 21