Table of Contents
Advertisement
22
www.zanussi.com
DAILY USE - DRYING (Only)
6.
1.
Press the On/Off button to turn on the
machine.
2.
Make sure the load size does not
exceed the maximum drying
capacity of the machine.
3.
Turn the knob to set a wash program
which can select drying option (refer
to Program Chart on page 11),
according to your clothes then press
Mode touchpad to switch your
machine to Dry Only Mode.
4.
If you wish to select an automatic
drying, press the "Dryness Level"
option until the icon corresponding to
the required dryness level appears on
the display. (see page 15)
5.
If you wish to select a timed drying,
press the "Time Dry
repeatedly until desired drying time
reached. (see page 14)
6.
Press "Start/Pause
start the program. The time remaining
is updated every minute.
7.
DAILY USE - WASHING & DRYING (Non-Stop Program)
7.1 Washing Program + "Dryness Level" Option
1.
Load the laundry and add detergent
and fabric softener. Make sure the load
size does not exceed the maximum
drying capacity of the machine.
2.
Turn the knob to set a wash program
which can select drying option (refer to
Program Chart on page 11), according
to your clothes then press Mode
touchpad to switch your machine to
Wash + Dry Mode.
3.
Select the required options by
pressing the relevant touchpads. If
possible, do not select a spin speed
lower than that proposed by the
machine to avoid unnecessary longer
drying time therefore saving energy.
The water tap must be open
and the drain hose must be
positioned in the sink or
connected to the drain pipe.
" option
" touchpad to
7.
At the end of the program :
-
The acoustic signal will operate.
-
The display will show "
"Anti Crease (
-
The door lock indicator "
on.
-
The appliance will perform the anti-
crease phase for approximately 10
minutes.
After anti-crease phase finish, the
door lock indicator "
The display will show "
If you wish to open the door
during the anti-crease phase
or interrupt it, press
Start/Pause touchpad.
8.
Press "On/Off" button to switch the
machine off.
At the end of each drying cycle,
9.
the temperature of your clothing
will be high. For your safety,
please leave the door open to
let your clothes cool before
removing your laundry.
4.
Set the dryness level by pressing
"Dryness Level" touchpad.
The display will then show the whole
duration of wash & dry cycle.
If a program is not compatible
with the drying option selected,
the symbol "
display.
5.
Start the program by pressing
Start/Pause touchpad. The time
remaining is updated every minute on
the display.
" and
)" icon is lit.
" is still
" goes off.
".
" will flash on
Advertisement
Chapters
Table of Contents
