Ecco ED3777 Series Assembly, Installation And Operation Instructions page 3

Wiring Instructions:
Important!
This unit is a safety device and it must be
connected to its own separate, fused power point to assure its
continued operation should any other electrical accessory fail.
Wire as shown in FIGURE 1. All wiring should be a minimum of 20 AWG. The positive line must have a slow blow 3 amp fuse. Routing the ground wire
directly back to negative battery terminal is recommended. Pack dielectric grease, such as Dow Corning 4, around each electric connection exposed to
moisture or the ambient environment. Isolate any unused wires.
FUSE (3A)
(USER SUPPLIED)
GREEN -
PUDDLE LIGHT -
POSITIVE
SWITCH
(USER SUPPLIED) ORANGE -
TAKEDOWN -
POSITIVE
SWITCH
(USER SUPPLIED)
SWITCH
(USER SUPPLIED)
SWITCH
(USER SUPPLIED)
BLACK - GROUND
FIGURE 1
WHITE -
POSITIVE
(DUAL
COLOR ONLY)
RED - POSITIVE
BLUE - FLASH PATTERN SELECT
(MOMENTARY TO
GROUND), DIM (TO POSITIVE)
YELLOW (SYNC)
Page 3 of 6