Control Panel - Bass Habit Play PP70.2 G2 User Manual

CONTROL PANEL

Bass Habit Play Power 2-channels amplifiers can be used for both speakers and subwoofers.
While listening to music, adjust the gain/crossover/subsonic/bass boost for the least per-
ceived distortion from the speakers, allowing them to reproduce as much bass as possible.
Input level control (GAIN):
GAIN control is a seamless adjustable between 0.2V - 6V.
Tips for adjusting the GAIN control correctly:
- Initially turn the GAIN control to minimum (counter clockwise).
- On the source unit, increase the volume control to the 3/4 of maximum volume.
- Slowly increase the GAIN control until you hear slight distortion in the speaker/speakers.
- Then reduce the GAIN slightly until distortion is no longer heard.
Bass Boost control (BASS BOOST):
Bass Boost is adjustable between 0, 6, 12 db (@ 45Hz)
Please use the BASS BOOST knob with care, excessive use can damage you system!
LPF Crossover (LPF):
The low pass filter is seamless adjustable between 50Hz - 500KHz. When using a subwoofer,
set the frequency cut point at 60Hz and adjust to your own preferences.
HPF Crossover (HPF):
The high pass filter is seamless adjustable between 50Hz–3KHz. The HPF can be used for
removing the deepest bass notes from the subwoofer, get a tighter and more rhythmical
sound. For a normal setup the HPF should be adjusted to the "50 Hz" setting.
Power status & Protection LED:
• POWER = Power LED lights up when the amplifier is turned on. Normally during the start-up
sequence the POWER and PROTECT lights will flash as a selft test procedure.
• PROTECT = Protect LED light flashing or solid. This light is an indicator of the protect mode
status, see the trouble shooting section of the manual for more information.
Line Input:
Connect the line outputs from your source unit and connect to the Line L and R inputs.
- 8 -