Bass Habit Play PP600.1 G2 User Manual page 9

Bridge In/Output (BRIDGE IN/OUT)
Two separeate Bass Habit Play Power mono amplifier G2 (same model) can be linked to power
a minimum 2 Ohm subwoofer setup for increased power output. Follow these instructions
carefully, if not carried out correctly you may permanently damage your products.
The power cables on both amplifiers need to be of the same size and quality. Consult your
local Bass Habit dealer to make sure that you have the right size cables and fuses.
The settings on the main amplifier (AMP1 in the illustration) will be operational, the settings on
the linked amplifier (AMP2 in the illustration) will not.
Use a high quality RCA cable to connect the two amplifiers, the link connects from the BRIDGE
OUT on AMP1 to BRIDGE IN on AMP2.
Connect as the Illustration. Bridge the negative (-) speaker connectors on each amplifier and
connect AMP1negative speaker terminal to AMP2 negative speaker terminal.
Bridge the positive (+) speaker connector and connect the speaker cables to your subwoofer
setup. IMPORTANT: The minimum load is 2 Ohm, this only possible with two (2) Bass
Habit PP600.1 G2 or 1000.1 G2. Note: PP600.1 can NOT be linked with PP1000.1
BRIDGE CONNECTION PP600.1 G2
AMP 1 AMP 2
AMP 1 AMP 2
- 9 -
Total subwoofer
setup min. 2 Ohm