Cushman HAULER 1200X EFI 2019 Owner's Manual page 41

Item
S General lubrication
Throttle/governor linkage
E Fuel system
Front axle
Parking brake
S Engine electrical system
S Rear suspension
S Front suspension
Front wheel alignment
S Battery
King pins
Rear axle
S
Air filter
E
CVT belt
Direction selector
Steering
Rack end ball joint
S Air Filter
S Oil filter
S Engine oil
S Rear axle
S Front wheel bearings
S Brakes
S Muffler/exhaust system
Valves - intake/exhaust
S
Spark plug
E
Cylinder head and piston
Cylinder head and piston
Rear axle
Interval
(perform at interval
that comes first)
Hours Calendar
50 3 Months Lubricate all fittings, pivots, cables, etc. where required.
50 3 Months Check operation and governed speed.
50 3 Months Check for leakage at tank, cap, lines, filters, pump, carburetor.
50 3 Months Check for damage, loose or missing hardware.
Inspect linkage rods, latch arm, catch bracket.
50 3 Months
Lubricate with light oil (Do not lubricate cables or brake latch).
50 3 Months Check coil/spark plug wires for cracks or loose connections.
Inspect shocks for leaks, worn bushings, loose or missing
50 3 Months
hardware.
Inspect strut for leaks. Check hubs and kingpins, for excessive
50 3 Months
play, worn bushings, loose or missing hardware.
50 3 Months Inspect for unusual tire wear; align if necessary.
125 6 Months Inspect terminals. Clean as needed.
125 6 Months Check for excessive play and tightness of retaining nuts.
125 6 Months Check for unusual noise, loose or missing hardware.
125 6 Months Inspect; clean as necessary.
125 6 Months Inspect for cracks, fraying and excessive wear.
Check for wear and smooth movement; lubricate shaft with
125 6 Months
light oil if necessary.
125 6 Months Inspect bellows and pinion seal for damage and leakage.
125 6 Months Check for noise and loose or missing hardware.
250 Yearly Replace.
250 Yearly Replace (with oil change).
Replace. See RECOMMENDED LUBRICANTS AND FLUIDS
250 Yearly
on page 40 for type and capacity.
250-300 Yearly Check fluid level; add if required.
250-300 Yearly Check and adjust as necessary.
Clean and adjust.
250-300 Yearly
Check brake shoe linings; replace if necessary.
Check hardware. Inspect for leaks at head and muffler gas-
250-300 Yearly
kets.
250-300 Yearly Check cold.
250 Yearly Replace and gap new.
500 5 years Remove carbon.
500 5 years Check valve seats for carbon buildup; clean if necessary.
500 5 years Replace fluid.
M
AINTENANCE
Remarks Page
40
53
40
50
39