Siemens EQ.500 classic Information For Use page 29

Fault
No milk intake by the
milk system.
Milk froth is too cold.
Appliance is not dis-
pensing hot water.
Appliance is not dis-
pensing drinks.
There is dripping wa-
ter on the inner floor
of the appliance.
Brewing unit cannot
be removed.
Appliance cannot be
operated.
Change displays.
Grinder won't start.
Grinder is not grinding
any coffee beans des-
pite full bean con-
tainer.
Display shows "Close"
despite the fact that
the door is closed.
Cause and troubleshooting
Milk tube not immersed in milk.
▶ Use more milk.
▶ Check whether the milk tube is immersed in the
milk.
Milk is too cold.
Use lukewarm milk.
▶
Milk system is soiled.
▶ Clean the milk system in the dishwasher.
Air is in the water filter.
Immerse the water filter in water with the opening
1.
facing upwards until no more air bubbles escape.
Reinsert the filter.
2.
→ "Inserting and activating the water filter", Page 16
▶ Firmly press the water filter straight down into the
tank connection.
Residues of limescale remover are blocking the water
tank.
Remove the water tank.
1.
Clean the water tank thoroughly.
2.
Drip tray was removed too soon.
▶ Wait a few seconds after the last drink was dis-
pensed before removing the drip tray.
Brewing unit is not in the removal position.
▶ Switch the appliance back on.
Appliance is in demo mode.
Remove the water tank and fill with fresh cold wa-
1.
ter.
Reinsert the water tank.
2.
Appliance is too hot.
Disconnect the appliance from the mains.
1.
Wait 1 hour so the appliance can cool down.
2.
Beans are too oily and are not falling into the grinder.
▶ Gently tap the bean container.
Change the coffee variety.
▶
▶ Do not use oily beans.
▶ Clean the empty bean container with a damp cloth.
Door is not properly closed.
▶ Press the door firmly shut.
Appliance is too hot.
Troubleshooting en
29