A Quick Look at the OneLINK Device
This section covers the physical features of the OneLINK Bridge Express AV interface.
Front Panel of the Receiver
USB light – On when a USB stream is active.
n
Network light – On when connected to the IP network.
n
Source light – On when a video input is detected.
n
Display IP and MAC Address button (illuminated blue) – Displays the OneLINK Bridge IP and MAC
n
addresses as an overlay on all video outputs.
Power System Reset button (illuminated red) – reboots the device. This does not affect the
n
connected camera.
Connector Panel of the Receiver
From the left:
Power input jack – Connect the supplied 48 VDC, 1.36 A power supply.
n
OneLINK interface port – Connection to the HDBaseT camera: video, audio (if available), network
n
connectivity including H.264 IP streaming from the camera (if available), RS-232 control, and 12 VDC
camera power.
HDMI output – Connection for a display.
n
n
USB 3.0 – Connect to a computer for uncompressed video output with PCM audio for conferencing
applications.
Network port – Web interface access, H.264 IP streaming (if available from the camera), and third-
n
party IP control via Telnet API.
RS-232 port – Connection for a camera controller or third-party control system.
n
Audio I/O Line Out 1 and Line Out 2 – Far-end audio from conferencing application or as
n
configured in the audio matrix.
n
Audio I/O Mic/Line In 1 and Mic/Line In 2 – Connections for microphones or other audio inputs.
Complete Manual for the OneLINK Bridge Express AV Interface
2