Configuring A Static Ip Address For A Device Currently At 169.254.10.1 - LEGRAND VADDIO OneLINK Bridge Express Manual

Configuring a Static IP Address for a Device Currently at 169.254.10.1

N
ETWORKING PAGE
These settings are for the OneLINK device only. The camera is configured separately.
If the device is currently at an IP address other than 169.254.10.1, skip this section.
By default, the device is set to DHCP, and will receive an IP address automatically if your
network assigns IP addresses. However, if no DHCP server is available to automatically assign an
address, the device uses its default IP address of 169.254.10.1. If you install more than one OneLINK
device on a non-DHCP network, you must follow this procedure to prevent IP address conflicts.
Caution
Consult your IT department before editing network settings. Errors in network configuration can make the
device inaccessible from the network. Do not change DHCP/Static addressing, IP address, subnet mask,
or gateway unless you are very familiar with the characteristics and configuration of the network where
you install the device.
To access the device's Networking page after initial device setup:
1. Leave the device connected as for initial device setup.
2. Log in to the web interface, if you have not done so already.
3. On the Networking page, set IP Address to Static; then enter the IP address, subnet mask, and
gateway as directed by the network specialist. You will need to log in again after saving your changes.
The device is now ready to be connected to the network.
Complete Manual for the OneLINK Bridge Express AV Interface
16