Lcd Monitor (Pm300-Btj Only); Monitor Symbol Explanation - Projecta IntelliJay PM300-BTJ Instruction Manual

5.2 LCD Monitor (PM300-BTJ only)

Date
Water tank 1
Water tank 2
Water tank 3
Water tank 4
Power Source
Solar charge
Water pump
Alarm error code
Hot Water Service/Back button
Pump/Up switch
The PMLCD-BTJ monitor can be paired to a smart phone via the smart device app. This app will display the battery parameters, water tank
levels, allow pump control and power isolation. Refer to section 6.3 for the Bluetooth pairing procedure.
5.2.1 LCD Monitor Symbol Explanation
No. DESCRIPTION
1 Water level
Water Tank 1
Water Tank 2
Water Tank 3
Water Tank 4
2 Working Mode
3 Power
4 Water Pump
5 Alarm Error Code
6 VCR connection
7 Output power
Table 8 Symbol Explanation
16
Time
Figure 23 An overview of monitor
COMMENTS
0%-25%-50%-75%-100%
EMPTY Flashing, the water is less than the recommended level
FULL Flashing, the gray water or waste water is more than the alarm level
MAINS AC mains status
CHARGE ONLY Battery charger only
Status of DC-Load switch in system: on / off
ON
Load
BATTERY DC loads are powered by battery
Pump 1 is ON
Pump 1 is OFF
Overload alarm
Over temperature alarm
System error code. Refer to the error codes on page 20
!
Voltage charging relay (VCR) is connected
Voltage charging relay (VCR) is disconnected
Voltage of system output
Current of system output
Bluetooth
Temperature
Output power
Charging state
House Battery:Type/Capacity
House Battery: Voltage/Current/Time to go
House Battery SOC (State of Charge)
Voltage of vehicle battery
VCR connection
Dim/Enter/Setting switch
PWR /Down Switch