Rompa SOUTHPAW GLIDER BOLSTER 18463 Assembly Instructions Manual

SOUTHPAW GLIDER BOLSTER 18463
Read these instructions thoroughly and keep them in a safe place. An additional copy may be
downloaded from the ROMPA website should you lose your original.
Suspension System not included - see ROMPA Catalogue for details of Hanging Bracket (13672),
Safety Snaps (13799), Safety Rotational Device (13738), Height Adjuster (13626).
Note: A Safety Rotational Device must be used

CONTENTS

1 x Glider Bolster
2 x Safety Snaps
1 x Maintenance Check List
NOTE: All hanging equipment requires a minimum ceiling height of 7 feet/approximately 2.5
metres and should be positioned a clear distance of 6 feet/1.8 metres from any adjacent walls and
other obstacles.

ASSEMBLY

The Glider Bolster may be suspended from two or four suspension points. If you choose to use
four suspension points you will require two additional safety snaps.
We recommend the use of Height Adjusters and Safety Rotational Devices although these are not
included. Use Southpaw Therapy Rope and Eye Splice with the Southpaw Height Adjuster.
Attach your Glider to your ceiling eye bolts with the Safety Snaps provided (and any extra ones
purchased separately).
The recommended suspension points for the Glider Bolster must be between 168cm (5.5ft) and
198cm (6.5ft) apart as this is the most stable configuration. The Glider Bolster may also be
suspended from a single suspension point.
If suspending your Glider Bolster from four points the second set of suspension points should be
parallel to the first set – approximately 45-61cm (1.5-2ft) apart from each other.
The Glider Bolster is designed with different
density foams on each side for the comfort of your
clients. The top (blue) has one layer of soft foam
and the bottom (green) has two layers of soft foam.
Consider which side will be uppermost before
suspension.
The Glider Bolster is stable in both
orientations.