Using The Monitor Screen To View System Activity - ADC PAIRGAIN HiGain HDSL2 Manual

Monitoring System Activity and Performance
U M
SING THE ONITOR
1 Press M to view the system diagram.
Figure 13 shows an armed circuit with an active loopback and alarms. Terms used on the system diagram are
defined in the onscreen Help menu glossary. Abnormal situations are highlighted on the diagram. See
Table 14 on page 33
DS1 Errors
Monitor Performance
ESF +---+
B8ZS |H2C|
------->|-+ |
| | |
ARM | | |M =19
| | |LA=25
ES =3 | | |
SES=3 | | |=MAL
UAS=0 | | |
| | |ES =41
| | |SES=41
ESF | | |UAS=38
B8ZS | | |
<-------<-+ |
|LPF|
+---+
----------------------------------LOOPBACKS------------------------------------
Active Loopback: NLOC-PL
Press <Space> to select LB
and <Enter> to activate
ID: xxxx--xxxx--xxxx--xxxx
Line code and framing
2 To initiate a loopback, press the
choice,
When prompted with the message: Are you sure (Y/N)?,press
cancel. For more information about loopbacks and troubleshooting, see
3 To initiate a loopdown of all active loopbacks, press the
N . When prompted with the message: Are you sure (Y/N)?,press
to cancel.
32
S
CREEN TO
for screen field descriptions.
Armed mode Margin
Event Log Config
==========================================|
New Loopback:
04/15/00 12:30:01
Active loopback
Figure 13. Monitor Screen - Active Loopback with Alarms
SPACEBAR to cycle though the loopback choices. Press
April 21, 2000
V S
IEW YSTEM
Loop attenuation Alarm type
Inventory Rlogon
ES =1
SES=1
UAS=0
NLOC - Loopback H2TU-C towards Network
(LPDN,NLOC,CREM,NREM,CLOC)
H2TU-C
SPACEBAR to select LPDN, then press
152-231-115-03, Revision 03
A
CTIVITY
HDSL2 Errors
Help
+---+
|H2R|
| |-AIS ->
| |
M =18 | |
LA =25 | |
| | ES =1
| SES=1
| | UAS=0
| | PRM=0
| |
| |
| |
| |
| |<-RLOS -
+---+
System: Alarm
System status
ENTER to make your
Y
to initiate the loopback or
"Testing" on page 45.
ENTER
Y to initiate the loopdown or
H2TU-C-231 List 1E
N
to
. or
N