Nielsen CT2880 Original Manual page 4

anyway) for an application it is not designed for.Select the machine appropriate for the size of
the job.Overloading the machine will result in its failure and user injury: This covers the use of
accessories.
Dress properly. Loose clothing, long hair and jewellery are all dangerous because they can
become entangled in moving machinery:This can also result in parts of body being pulled into
the machine. Clothing should be close fitted, with any long hair tired back and jewellery and
neck ties removed. Footwear must be fully enclosed and have a nonslip sole.
Wear personal protective equipment(PPE). Dust, noise, vibration and swarf can all be
dangerous if not suitably protected against. lf the work involving the power tool creates dust or
fumes; wear a dust mask.Vibration to the hand, caused by operating some tools for longer
periods must be protected against. Wear vibration reducing gloves and allow long breaks
between uses. Protect against dust and swarf by wearing approved safety goggles or a face
shield.These are some of the more common hazards and preventions; however,always find
out what hazards are associated with the machine/work process and wear the most suitable
protective equipment available.
Move the machine as instructed.Always refer to the instructions for the correct method.
Do not overreach.Extending your body too far can result in a loss of balance and you
falling.This could be from a height or onto a machine and will result in injury.
Maintain your tools correctly. A well maintained tool will do the job safely.Replace any
damaged or missing parts immediately with original parts from the manufacturer.As
applicable;keep blades sharp; moving parts clean, oiled or greased; handles clean; and
emergency devices working.
Wait for the machine to stop. Unless the machine is fitted with a safety brake; some parts
may continue to move due to momentum. Wait for all parts to stop; then unplug it from the
power supply before making any adjustments, carrying out maintenance operations or just
finishing using the tool.
Remove and check setting tools.Some machinery requires the use of additional tools or
keys to set, load or adjust the power tool Before starting the power tool always check to make
certain they have been removed and are safely away from the machine.
Prevent unintentional starting. Before plugging any machine in to the power supply, make
sure the switch is in the OFF position. If the machine is portable; do not hold the machine near
the switch and take care when putting the machine down; that nothing can operate the switch.
This machine is not suitable for use with an extension lead.
Concentrate and stay alert. Distractions are likely to cause an accident. Never operate the
machine if you are under the influence of drugs (prescription or otherwise), including alcohol or
if you are feeling tired.Being disorientated will result in an accident.
Have this machine repaired by a qualified person. This machine is designed to conform to
the relevant international and local standards and as such should be maintained and repaired
by someone qualified; using only original parts supplied by the manufacturer:This will ensure
the machine remains safe to use.