Table of Contents
Advertisement
• If there is tube in the tire, remove it.
• Lift wheel, make the bottom edge of wheel
onto mounting head as Fig. 23.
• Press pedal D until bottom edge of wheel fall off.
• Depress pedal A, tilt column, take off wheel,
and finish demounting.
Caution:
Keep hands and the rest of human body away from
Fig.23
the moving parts of the machine. Never wear
necklace, bracelet or loose clothes when operating
the machine as it may cause danger!
Mounting Tire
Note: Check the size of tire and rim to see if they match each other.
• Clamp the rim tightly in the same way as demounting tire.
• Use lubricant such as thick soap solution on the tire and the rim.
• Put the bead on the rim with the left side upward, press pedal A to make column back to its
working position (Fig.24).
• Check the coordination of mount/demount head and rim. Readjust if necessary.
• Adjust relative position between the tire and the mount/demount head to make the tire
bead cross the mount/demount head. At the end of the mount/demount head, the tire bead
should be placed on the mount/demount head (Fig.25-A). At the beginning of the
mount/demount head, the tire bead should be placed under the ball protuberance of the
mount/demount head (Fig.25-B).
• Press down the central part of the tire. Depress the pedal D (Fig.20) to turn the turntable
clockwise, making the lower tire bead fall into the rim groove completely.
Fig.25
Fig.24
Advertisement
Table of Contents
