Table of Contents
Advertisement
of rim to avoid mounting head scratch rim
• Insert lever into wheel near mounting head (Fig. 20).
• Press lever as Fig. 20-2 and press wheel as fig. 20-1, until upper edge of wheel as Fig. 21,
press lever slowly, until upper edge of wheel hang on the mounting head.
Note: If there is inner tube inside, keep the position of air inlet valve and mounting head at
distance of 10cm. as Fig. 22.
• Press pedal D (Fig. 20), turntable turn clockwise, until edge of wheel fall off.
Fig.19
Fig.20
Note: For very tough and low profile wheel, wheel edge is easy to slip off, to avoid this, before
turn clockwise of the turntable, may turn anti-clockwise a little to make the turntable back
1-2mm.
•
If the demounting process is prevented, stop the turntable from turning around, lift pedal D
(Fig. 20), let the turntable turn anti-clockwise.
Fig.21
Fig.22
Advertisement
Table of Contents
