Table of Contents
Advertisement
NOTE：The tire changer is not equipped with overload protection. Please connect power
according to the electric diagram included in the User's manual. Otherwise, the manufacturer
will not be responsible for any accidents.
• Operation test: after power connected, press
pedal D (Fig.11), turntable will turn clockwise.
This test is very important.
• F.R.L. :Filter, Regulator, Lubricator Assembly
(optional):
◆ See Fig. 12：
1- Lubricator；2- Filter；3- Regulator
◆ Adjust pressure: There is a button for the regulator
When pulled up, the pressure can be increased
or decreased by turn it clockwise or counter-clockwise
(check the 4-Gauge). After adjusting the operation
pressure, press the button down to lock it
The Filter 2 works to filter the water and impurity
in the compressed air. When water and impurities
run beyond the red line, turn open the ejection valve
5 to release them.
◆ The lubricator 1 is used to add a certain amount
of lubricant into gas for the moving parts in the cylinder
and regulator. Depress pedal C, 3～5 times,
a drop of lubricant will drop into the cup in the regulator.
If it doesn't happen, the adjusting screw 6 can be
adjusted.
Fig.11
3
4
2
1
5
6
Fig.12
Advertisement
Table of Contents
