Advertisement
安装花洒头之前袁先打开水源冲洗
掉杂质遥
对于 12180T袁取出垫片(3)袁按图
示方向放入限流器(2-1)遥
对于 3867T袁安装限流器(2-2)和
垫片(3)遥
对于 15343T袁安装限流器(2-3)和
垫片(3)遥
在花洒臂(4袁客户自备)螺纹上缠
绕足以密封的密封胶带或涂适合
的密封胶袁用带状扳手将花洒头
(1)旋到花洒臂上遥
院若水压过低袁不需要安装限流
器遥 水压超过 0.3Mpa渊3Bar冤袁花洒
必须安装限流器遥
喷孔杂质或结垢会导致水流变形袁
流量变小遥 打开水源袁用力按压或
摩擦橡胶喷孔袁去除杂质或水垢遥
适用于所有加工处理过的表面院以中性肥皂水清
洗镀层表面袁再以干净的软布彻底擦干整个表面遥
许多清洁剂袁比如氨水尧去污粉及洁厕灵等袁会对电
镀表面造成伤害袁切忌使用遥
有磨损性的清洁用具或清洁剂也不可使用于科勒
牌的水龙头及其配件上遥
1075720-2-A
4
3
2-1
2-2
2-3
All Finishes: Clean the finish with mild soap and warm
water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as
ammonia, chlorine, toilet cleaner etc. which could
adversely affect the finish and are not recommended for
cleaning.
Do not use abrasive cleaners or solvents on Kohler
faucets and fittings.
Flush both water supplies through the
shower arm(4, not provided) for about one
minute to remove debris thoroughly before
the installation.
For 12180T, take out the washer(3), put
the restrictor(2-1) into the ball joint as the
figure shown.
For 3867T, install the restrictor(2-2) and
the washer(3) into the ball joint.
For 15343T, install the restrictor(2-3) and
the washer(3) into the ball joint.
1
Apply enough tape or sealant to the threads
of the shower arm. Tighten the shower
head(1) with a strap wrench.
院 If the working pressure is too low,
the restrictor is not needed. Restrictor must
be installed if water pressure exceeds
0.3Mpa(3bar).
Any debris or mineral build-up may cause
the flow stream to become distorted or
reduce the flowrate. To remove the debris
or mineral build-up, run water through the
shower head, firmly press or rub your
finger back and forth across the rubber
nozzles.
Advertisement
