Installing The Switch In A 19-Inch Rack; Rack-Mounting Procedures At A Glance; Rack-Mounting Requirements - H3C S6850 Series Installation Manual

Installing the switch in a 19-inch rack

Rack-mounting procedures at a glance

Figure2-2 Rack-mounting procedure
Determine the installation
position (near the power
module side or port side )
for the mounting brackets
NOTE:
If a rack shelf is available, you can put the switch on the rack shelf and slide the switch to a position
so that the mounting brackets make close contact with the front rack posts. Then use screws to
secure the mounting brackets to the rack.

Rack-mounting requirements

Figure2-3 S6850-56HF chassis dimensions (mounting brackets installed at the port side,
left-side view)
1
43.6 mm
(1.72 in)
26 mm (1.02 in)
(1) Power module handle
Figure2-4 S6850-56HF chassis dimensions (mounting brackets installed at the power module
side, left-side view)
1
43.6 mm
(1.72 in)
26 mm (1.02 in)
(1) Power module handle
Attach the mounting Attach the chassis
brackets to both rails to both sides
sides of the switch
2
Connect the
grounding cable to
of the switch a grounding point
460 mm
(18.11 in)
(2) Mounting bracket
460 mm
(18.11 in)
(2) Mounting bracket
2-5
Attach the slide Install the switch
rails to the rack in the rack
2