Connecting The Grounding Cable To The Chassis - H3C S6850 Series Installation Manual

Figure2-33 Attaching the mounting brackets and chassis rails to the S9850-32H switch
(power module-side mounting position for the mounting brackets)
NOTE:
Secure the mounting brackets and chassis rails to both sides of the chassis in the same way.

Connecting the grounding cable to the chassis

IMPORTANT:
• If the grounding cable length or terminal type cannot meet your requirement, make an applicable
grounding cable or contact H3C Support.
• If you use a grounding point on the side panel to ground the switch, connect the grounding cable
to the grounding point before installing the switch in the rack.
For an S6850-56HF, S6850-2C, or S9850-32H switch, the primary grounding point and auxiliary
grounding point are on the left side panel. Both grounding points support a grounding cable that has
a single-hole lug or dual-hole lug. Use M5 grounding screws to attach the grounding cable to the
switch. Choose the grounding point according to the mounting bracket installation positions.
•
If you install the mounting bracket at the port side, connect the grounding cable to the grounding
point at the port side.
•
If you install the mounting bracket at the power module side, connect the grounding cable to the
grounding point at the power module side.
For an S9850-4C switch, the primary grounding point and auxiliary grounding point 1 are on the left
side panel, and auxiliary grounding point 2 is on the rear panel. If you use a grounding cable that has
a dual-hole lug, connect it to the primary grounding point or auxiliary grounding point 1. If you use a
grounding cable that has a single-hole lug, connect it to auxiliary grounding point 2. Use M5
grounding screws to attach the grounding cable to the switch. Choose the grounding point according
to the mounting bracket installation positions.
To connect the grounding cable:
1. Choose a grounding point as required.
2. Unpack the grounding cable and grounding screws.
d
c
2-20