Specifications - Shindaiwa EB633RT Operator's Manual

SPECIFICATIONS

1. Store unit in a dry, dust free place, out of the reach of children.
2. Place the stop switch or lever in the "OFF" position.
3. Remove accumulation of grease, oil, dirt and debris from exterior of
unit.
4. Perform all periodic lubrication and services that are required.
5. Tighten all the screws and nuts.
6. Drain fuel tank completely. Press purge bulb 6 -7 times to remove
remaining fuel from carburetor then drain the tank again. Close choke,
start and run the engine until it stops due to lack of fuel.
7. Allow engine to cool. Remove the spark plug lead from the spark plug.
Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke
engine oil into the cylinder through the spark plug hole.
8. Pull the recoil starter handle 2-3 times to distribute the oil inside the
engine.
9. Observe the piston location through the spark plug hole. Pull the recoil
handle slowly until the piston reaches the top of its travel and leave it
there.
10. Install the spark plug. Connect the spark plug lead to the spark plug.
11. Remove blower pipe assembly from unit.
SPECIFICATIONS
MODEL
Length
Width
Height
Weight (dry)
Engine Type
Bore
Stroke
Displacement
Exhaust
Carburetor
Ignition System
Spark Plug
Fuel
Fuel/Oil Ratio
36
EB633RT
375 mm (14.8 in.)
485 mm (19.0 in.)
527 mm (20.8 in.)
11.0 kg (24.9 lb.)
Air cooled, two-stroke, single cylinder gasoline engine
48.0 mm (1.89 in.)
35.0 mm (1.38 in.)
3
63.3 cc (3.86 in. )
Spark arrester muffler or spark arrester muffler with
catalyst
Diaphragm with purge pump
Flywheel magneto, capacitor discharge ignition type
NGK BPM8Y (BPMR8Y in Canada)
Gap 0.65 mm (0.026 in.)
Mixed (gasoline and two-stroke oil)
50:1
EB633RT
X7531124908
© 04/22 ECHO Incorporated