Starting Warm Engine - Shindaiwa EB633RT Operator's Manual

EB633RT
2.
Choke
Move choke (C) up to COLD
START ( ) position.
3.
Purge Bulb
Pump purge bulb (D) until fuel is
visible and flows freely in the
clear fuel tank return line. Pump
bulb an additional 4 or 5 times.
4.
Recoil Starter
Pull recoil starter handle (E) until engine fires (5 or 6 pulls maximum).
5.
Choke
Move choke (C) down to RUN (
engine.
Note: If engine does not start after 5 pulls, move choke to COLD
START (
Note: Allow engine to warm up before use.

Starting Warm Engine

The starting procedure is the same as Cold Start except DO NOT close the
choke.
1.
Throttle Position / Stop Switch
Button
Move throttle position lever (A)
forward to IDLE position. Slide
stop switch (B) forward to RUN
position.
2.
Recoil Starter
Pull recoil starter handle (E) and
engine should start. Do not use
choke (C).
Note: If engine does not start
after 5 pulls, use cold start
procedures.
X7531124908
© 04/22 ECHO Incorporated
) position, and repeat steps 4 & 5.
C
D
) position, and if necessary, restart
A
OPERATION
E
B
E
C
23