Assembly; Install Blower Pipes - Shindaiwa EB633RT Operator's Manual

EB633RT

ASSEMBLY

Never perform maintenance or assembly procedures with
engine running or serious personal injury may result.

Install Blower Pipes

1. Assemble clamps (A) and (G)
onto both ends of flexible pipe
(B).
Note: Clamp with cable guide
loop (G) fits elbow end of
flexible pipe.
Note: A light lubricant may be
used to ease assembly of
flexible pipe to blower
elbow.
2. Assemble flexible pipe to elbow
(D) on blower. Position clamp
with cable guide loop (G) on
outside of flexible pipe and
tighten clamp.
Note: Hang handle freely from
blower to assure throttle
cable is not twisted
before installing handle
(E).
3. Position throttle cable
along the outside of
elbow. Loosen knob
(H) on handle (E).
Align notches in
handle with tabs (F)
and install onto swivel
pipe (C) past long
ridges in pipe.
4. Assemble swivel pipe
into flexible pipe and
tighten clamp (A).
5. Clip throttle cable into throttle cable guide loop.
6. Move handle (E) to desired position. Tighten knob (H) hand tight.
X7531124908
© 04/22 ECHO Incorporated
G
D
G
ASSEMBLY
G
A
B
D
G
E
B
A
H
C
F
17