Table of Contents
Advertisement
INSTALLATION
Your fan should only be installed once the unit is
in place in order to prevent any damage to the
fan. To attach, follow the instructions provided
with the fan. Make sure to install the rubber
grommet to the fan housing before it is installed
on the insert.
1) Remove the protective covering from the
brass trim on the fan.
2) Align the fan support with the offset clip on
the bottom of the ashlip.
f i r e - p a r t s . c o m
Neutral
Live
120V AC
60 Hz
Fan Thermodisc
(normally open)
10
FAN / BLOWER
3) Slide the supports into the clips. The tension
holding the clips in place may be adjusted by
increasing or decreasing the offset spacing
of the clips.
4) Ensure that the power cord is not in contact
with any hot stove surfaces.
5) Push the Regency logo plate into the two
holes in the front bottom left corner of the
fan.
Green
Manual/
Ground
Auto
Switch
Black
Black
Blower/Fan Wiring Diagram
Do not turn fan ON until your insert has
reached operating temperature or at least
30 minutes after starting fi re.
CAUTION: Label all wires prior
to disconnection when servic-
ing controls. Wiring errors can
cause improper and dangerous
operation.
WARNING:
Electrical Grounding Instructions
This appliance is equipped with a
three pronged (grounding) plug for
your protection against shock hazard
and should be plugged directly into
a properly grounded three-prong
receptacle. Do not cut or remove the
grounding prong from this plug.
Fan
Switch
Black
Fan
Fan
Regency Wood Insert & Hearth Heater
Ground
Advertisement
Table of Contents
