Table of Contents
Advertisement
4.3.4 Set display mode
① Make sure it's Pattern Squence because it's easy to automatically jump to
Video Mode.
② Click Sequence Setting under Pattern Sequence.
③ Choose a color from the drop-down list, such as white.
④ Select the trigger mode, and select Internal Trigger when it is always on; for
external trigger, select External Positive or External Negative according to the rising
edge or falling edge of the trigger signal.
⑤ According to the order of the images generated by the firmware in the steps,
Flash Index 0 is the first image, and then select the number of image bits, we apply
selection 8.
⑥ Load signal. For example, Flash Index 0, that is, the first image uploaded is a
composite of three images, that is, it contains three kinds of display information,
select G0---G7 in the color bar, click Add Pattern to Sequence, and then select R0-
--R7, click Add Pattern to Sequence, then select B0---B7, click Add Pattern to
Sequence (the colors in the color bar are selected in no order, but cannot be repeated).
16
Advertisement
Table of Contents
