Kenwood FDP22 Instructions Manual page 9

the plate and not exit the food outlet, resulting in
damage to your attachment.
If the food is not exiting the food outlet, switch off
and check that food is not clogging under the disc
and the slinger plate is fitted. Clear any trapped
food before continuing to process.
Do not run the Express Serve attachment
continuously for longer than 2 minutes. Leave
to cool for 2 minutes in between each 2 minute
operation.
Cleaning
(refer to illustration)
Always switch off and unplug before cleaning.
Wipe the power unit with a damp cloth, then dry.
Ensure that the interlock area is clear of food debris.
Do not immerse the power unit in water.
Handle the blade and cutting discs with care - they
are extremely sharp.
Before plugging in
Make sure your electricity supply is the same as the one shown on the underside of your
appliance.
Important – Plug and Fuse Information
The wires in the cord are coloured as follows:
Blue = Neutral
Brown = Live
If the plug supplied with your appliance has a fuse fitted and the fuse fails it must be
replaced with one of the same rating.
If the plug or cord requires replacing a new cord set should be fitted by an Authorised
Kenwood Repairer.
Note:
For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse.
If the fuse cover is lost then the plug must not be used until a replacement can be
obtained. The correct fuse cover is identified by colour and a replacement may be
obtained from your Kenwood Authorised Repairer (see Service).
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric
shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted
into a socket outlet.
This appliance conforms to EC Regulation 1935/2004 on materials and articles intended
to come into contact with food.
Before using for the first time
1 Remove the plastic blade covers
from the knife blade. Take care
the blades are very sharp. These
covers should be discarded as they
are to protect the blade during
manufacture and transit only.
2 Wash the parts see 'Cleaning'.
3 Ensure the cord is fully unwound
before using the appliance.
4