ACDI
ACD3000 Series User & Technical Manual
Introduction
Overview
This document describes the operation and service of the ACD3000 series
copy/print controller. The ACD3000 series is an advance generation of
copy/print control, combining innovation and engineering to meet the demand of
the ever-changing market.
This ACD3000 series has up to 8 separate Price Lines to allow for the charging
of black and white copies, color copier, large paper sizes, scans, and faxes. For
Staff Copies, the ACD3000 series has an external keypad to allow User and
Supervisor copies at no charge.
The ACD3000 series is also equipped with a serial interface to allow for
communication with Print Management Software and an external printer for
reports and meter readings. This interface allows the ACD3000 to be field
programmable for software updates.
The ACD3000 series is available in a variety of options and configurations
including coin, bill, stored value, and credit card options.
The ACD3000 Series vending system will accept ACDI CopyMate Cards
intended for use with this system. Once the card is inserted, the display shows
the $ amount available, also known as ESCROW Amount. For normal
operation, when the escrow amount is greater than or equal to a given Price Line
the ACD3000 series will enable that feature on the Copier. The ACD3000
series receives signals from the copier that indicate a copy has been made and at
what Price Line. The copy is then metered by the ACD3000 series and a new
escrow value is calculated, in addition, Price Lines are re-assessed for validity.
Up to 8 distinct price lines are supported depending on copier or M.F.P. our card
reader is interfaced to. Press EJECT to retrieve card.
Staff Copies
Staff Copies are available using the Supervisor PIN, User PIN, or secondary
group cards. As copies are made in any of these modes, the ACD3000 meters
each copy and provides reports to verify usage. (Please refer to illustration 1.01)
Introduction
1
Need help?
Do you have a question about the ACD3000 Series and is the answer not in the manual?