Card Settings; Group 1 Code; Group 2 Code - Access Control Devices ACD3000 Series User Manual

ACDI

Card Settings

The ACD3000 series is equipped with the EX Technologies magnetic card
system. There are unique settings and card programming modes available only
in the card setting menu. The following pages will walk you through functions
specific to the card setting menu

Group 1 Code

1. Enter default Supervisor Pin– 73784230
Press ENTER display will read "Service Mode"
2.
Press ENTER display will read "Meters Menu"
3.
Press FWD until display reads "Setup Menu" Press ENTER
4.
Press FWD until display reads "Card Settings" Press ENTER
5.
6. Note you will step through several menus.
Press FWD until screen reads "Group 1 is 9" or current group 1 code.
7.
8. To change value of Group 1
the number of the new value
9. Press
10. Press ENTER to lock in the new value
11. Press Exit twice until screen reads "Setup Menu"
12. Press Eject to leave the Service Mode.

Group 2 Code

1. Enter default Supervisor Pin– 73784230
Press ENTER display will read "Service Mode"
2.
Press ENTER display will read "Meters Menu"
3.
Press FWD until display reads "Setup Menu" Press ENTER
4.
Press FWD until display reads "Card Settings" Press ENTER
5.
6. Note you will step through several menus.
Press FWD until screen reads "Group 2 is 2" or current group 2 code.
7.
8. To change value of Group 2
the number of the new value
9. Press
10. Press ENTER to lock in the new value
11. Press Exit twice until screen reads "Setup Menu"
12. Press Eject to leave the Service Mode.
– Setting is preset and should only be changed if instructed.
– Setting is preset and should only be changed if instructed.
ACD3000 Series User & Technical Manual
14