Table of Contents
Advertisement
Powering the Monitor
1. Place the monitor in a location with clear reception from your
camera(s).
2. If you are using the monitor as a stand-alone
unit, flip out the stand on the back of the
monitor and extend the antenna.
3. Insert one end of the DC cable to the
DC port on the side of the monitor.
4. Connect the other end of the DC cable into
the DC power adaptor.
5. Connect the DC power adaptor into a 240
volt AC (standard indoor) power outlet.
6. Press and hold the POWER button to turn
the unit on or off. Let the monitor charge for 6 hours prior to first time
use so the built-in rechargeable monitor battery is fully charged. DO
NOT remove the charging cable from the monitor during the initial
charge process. After the initial charge, recharge the monitor as
needed.
7. Out of range displays until you turn on the camera.
You can install additional cameras (maximum of 2 cameras). When
adding cameras that were not included in the original box, you will need
to pair the cameras with the monitor.
12
Advertisement
Table of Contents
