Monitor Installation; Camera Installation - Uniden BW6181R Series Owner's Manual

Powering the Camera
Insert one end of the micro USB cable to the micro USB port on the camera (at
the back of the camera).
Connect the other end of the USB cable into the USB power adaptor.
Connect the USB power adaptor into a 240 volt AC (standard indoor) power
outlet.
Switch on the plug and allow the camera to power up. The pairing indicator will
flash momentarily.

MONITOR INSTALLATION

Place the monitor in a location with clear reception from your camera(s).
If you are using the monitor as a stand-alone unit, flip out the stand on the back
of the monitor and extend the antenna.
Insert one end of the micro USB cable to the micro USB port on the side of the
monitor.
Connect the other end of the USB cable into the USB power adaptor.
Connect the USB power adaptor into a 240 volt AC (standard indoor) power
outlet.
Press and hold the POWER button to turn the unit on or off. Let the monitor
charge for 6 hours prior to first time use so the built-in rechargeable monitor
battery is fully charged. DO NOT remove the USB cable from the monitor during
the initial charge process. After the initial charge, recharge the monitor as needed.
# We recommend that the device should be fully charged once every three months
with the monitor switched off in order to prolong the device's battery life.
11