Error Codes - GE GFDR485EF Technical Service Manual

Error Codes

SSD Error Name
000 No Error
001 Inlet Thermistor
Short
002 Outlet Thermistor
Short
003 Inlet Thermistor
Open
004 Outlet Thermistor
Open
005 EEPROM Error
006 Stuck Button
007 Miswire
008 Door Switch Stuck 5 cycles are run and
009 Drum Motor
00d Door Signal Stuck
Error Set Condition
No Errors
Inlet Thermistor's
count of low readings
exceeds 10.
Outlet Thermistor's
count of low readings
exceeds 10.
Inlet Thermistor's
count of high readings
exceeds 10.
Outlet Thermistor's
count of high readings
exceeds 10.
Bad CRC Detected
when reading a
page from EEPROM.
Button depressed for 5
minutes.
L2/N are miswired.
the DOOR_LATCH_SIG-
NAL has not gone
open.
Centrifugal Switch does
not change within a
certain period of time
after the Drum Motor
relay has been turned
5 cycles are run and
the DOOR_STATE
signal in the hardware
Door Switch Detection
Circuit , has not gone
Error Clear Conditions
Inlet Thermistor's count
of good readings exceeds
10.
Outlet Thermistor's count
of good readings exceeds
10.
Inlet Thermistor's count
of good readings exceeds
10.
Outlet Thermistor's count
of good readings exceeds
10.
Error condition clears
when EEPROM checksum
is right .
When the button is re-
leased.
Cleared when voltage
drops to Normal Levels.
DOOR_LATCH_SIGNAL
goes to open.
Error condition will not
clear until Main Control
board sees a change in
the centrifugal switch.
Error condition will not
clear until the Main Con-
trol Board sees the door
switch change.
15
Error Response Action
Run Heat Control Fallback
Algorithm.
Run Heat Control Fallback
Algorithm.
Run Heat Control
Fallback Algorithm.
Run Heat Control
Fallback Algorithm.
Cleared when stuck but-
ton is released.
L2 and N need to be re-
wired.
Micro Blackout Recovery
to Run will not occur if this
error is set , and control
will go to pause.