Incandescent Drum Lamp; Incandescent Drum Lamp Strip Circuit; Incandescent Drum Lamp Removal; Front Drum Support - GE GFDR485EF Technical Service Manual

Incandescent Drum Lamp

Bulb
See Drum Lamp Location on page 17.

Incandescent Drum Lamp Strip Circuit

Terminal
Block
Door Switch
N
High Limit
Thermostat
L1
Operating Voltage: 120 VAC
Incandescent drum lamps are not present on all
models, some models have LED drum lamps.
See LED Drum Lamp Section on page 33.

Incandescent Drum Lamp Removal

1. Disconnect power from the unit .
2. Remove the control panel.
See Control Panel Removal on page 20.
3. Remove the front panel.
See Front Panel Removal on page 24.
4. Remove the front con-
trol assembly bracket assembly.
See Front Control Assembly Bracket Removal
on page 25.
5. Remove the bulb, then squeeze the lamp mount-
ing clips and pull the lamp socket out through
the inside of the drum.
Socket
To MCB J1-3
(Door Sense)
To Belt Switch
and Steam Valve

Front Drum Support Removal

1. Disconnect power from the unit .
2.
3. Remove the control panel.
Drum Lamp
On Some Models 4. Remove the front panel.
5. Remove the trap duct .
6. Remove the front con-
7. Disconnect the wires connected to the front
8. Remove the four 1/4 in. hex screws that secure
9. Lift front drum support out of the key holes.
34

Front Drum Support

See Control Panel Removal on page 20.
See Front Panel Removal on page 24.
See Trap Duct Removal on page 38.
trol assembly bracket assembly.
See Front Control Assembly Bracket Removal
on page 25.
drum support .
the front drum support to the side panels.
Harness Connector